[ale] HOW2 install BellSouth DSL with a USB link rather than Ethernet ?

[JK]

Ben Coleman wrote:

> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> Courtney Thomas wrote:
> 
>>Thanks Dan.
>>
>>It's true that the modem is instantly detected when plugged into the hub but
>>then what is required to render it functional  ?
>>
>>Are dns server addresses [2] required ?
> 
> 
> Presuming that you're running the stock Westell as BellSouth delivers it (i.e.
> you haven't configured it over into bridged mode), then if you set up your
> computer to obtain networking information (IP address, DNS addresses, etc) via
> DHCP, it should 'just work'.

The fact that the machine is plugged into a hub implies that there
are other machines connected to the hub as well.  In this case,
depending on how those other machines are configured, things
may get a bit more complicated.  You probably do not want
any machine other than your "router" machine asking the
modem for an IP address.

This is all a lot easier with two NICs, but it should be possible
to make things work out with only one.  Courtney may need to
give us more details about the network setup.

-- JK