[ale] mounting an SD card

[Paul Cartwright]

On Wed June 28 2006 11:17 am, Michael B. Trausch wrote:
> > Does it HAVE to open all of these windows????
>
> It probably detects three different types of devices. ?What does the
> kernel ring buffer (dmesg) say after you plug it in and the device
> is recognized?
if you said that in English and give me directions, I'd be able to give 
you a better answer;)
ok, looked up dmesg.. did a dmesg -c then plugged in my camera:
# dmesg
SFW2-INext-DROP-DEFLT IN=eth0 OUT= MAC= SRC=192.168.10.3 
DST=192.168.10.255 LEN=175 TOS=0x00 PREC=0x00 TTL=64 ID=0 DF PROTO=UDP 
SPT=631 DPT=631 LEN=155
usb 2-2: new full speed USB device using uhci_hcd and address 4
scsi1 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 4
usb-storage: waiting for device to settle before scanning
SFW2-INext-DROP-DEFLT IN=eth0 OUT= MAC= SRC=192.168.10.3 
DST=192.168.10.255 LEN=175 TOS=0x00 PREC=0x00 TTL=64 ID=0 DF PROTO=UDP 
SPT=631 DPT=631 LEN=155
  Vendor: OLYMPUS   Model: C750UZ            Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
sda: Write Protect is off
sda: Mode Sense: 18 00 00 08
sda: assuming drive cache: write through
SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
sda: Write Protect is off
sda: Mode Sense: 18 00 00 08
sda: assuming drive cache: write through
 sda: sda1
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi1, channel 0, id 0, lun 0,  type 0
usb-storage: device scan complete
SFW2-INext-DROP-DEFLT IN=eth0 OUT= MAC= SRC=192.168.10.3 
DST=192.168.10.255 LEN=160 TOS=0x00 PREC=0x00 TTL=64 ID=0 DF PROTO=UDP 
SPT=631 DPT=631 LEN=140
SFW2-INext-DROP-DEFLT IN=eth0 OUT= MAC= SRC=192.168.10.3 
DST=192.168.10.255 LEN=175 TOS=0x00 PREC=0x00 TTL=64 ID=0 DF PROTO=UDP 
SPT=631 DPT=631 LEN=155
PaulsPC:/home/pbc/Documents/software #                    
-- 
Paul Cartwright
Registered Linux user # 367800