[ale] Open suse 13 and display issues HDMI vs DVI

[James Taylor]

I've tried to send this twice already.
Hopefully it will get through this time. 

I had an issue with my monitors, where they would only work with what input they were set for.
When I changed input type, say from dvi to HDMI, nothing would show on the monitor.
I had to plug into a dvi port on the computer, then change the monitor settings using the on-screen settings for the monitor.
Even though the on-screen settings were part of the monitor, they wouldn't show up unless there was a recognized signal input from to the active port.
Really, really dumb, in my opinion.
-jt


James Taylor
678-697-9420
james.taylor at eastcobbgroup.com



>>> "Narahari 'n' Savitha" <savithari at gmail.com> 12/7/2014 2:19 PM >>> 
Any thoughts please ?

On Sun, Dec 7, 2014 at 12:15 AM, Narahari 'n' Savitha <savithari at gmail.com>
wrote:

> I am using open suse 13.  Got it installed when installed it was in the
> install fest.  At that time the display was the DVI display.  Now I don't
> have DVI display anymore but HDMI display with resolution of 1920x1080.
>
> When I power of my computer I don't see any display on my monitor with
> HDMI input.  If I conn with DVI it works fine.  I would like to use HDMI
> directly though.
>
> What should I tweak so the HDMI works right ?
>
> Kindly advise.
>
> Regards,
>
> -N
>


If this is an unsolicited spam message, please click this link to report it: http://control.eastcobbgroup.com:49285/contents/spamreport.shtml?rptid=62778&srvid=16vl15t