[ale] No eth0 with Opensuse 12.3 in virtualbox

[Mike Ivey]

I have not used Opensuse in a while but I would try typing ifconfig -a
to see if i can see the eth0 interface there. If so then run ifconfig
eth0 up, and dhcpd3 eth0 or dhclient eth0 to get an Ip address if you
have dhcp enabled on your LAN.

If it is not there then I would check the virtualbox Network settings.
Make sure Enable Network Adapter is checked for atleast one of the 4
adapters. Also make sure Attached to is either set to bridge or NAT
and that name has the interface on the host machine that you want to
use.

On Tue, Aug 13, 2013 at 11:34 AM, Jonathan Meek
<jonathan.l.meek at gmail.com> wrote:
> Hello everyone,
>
> I have got what I think is a dumb question but here goes it: I have just
> installed Opensuse 12.3 within virtualbox but I have no eth0 on the VM. I
> have pulled up ifconfig and it just tells me I have a feedback loop (lo).
> How would I begin to troubleshoot this?
>
>
> Regards,
>
> Jonathan
>
> _______________________________________________
> Ale mailing list
> Ale at ale.org
> http://mail.ale.org/mailman/listinfo/ale
> See JOBS, ANNOUNCE and SCHOOLS lists at
> http://mail.ale.org/mailman/listinfo
>