[ale] CD burner problems

Robert L. Harris Robert.L.Harris at rdlg.net
Mon May 12 14:32:44 EDT 2003



Try different media.  I had a bad CDR in a batch of 50.  When I replaced
that one it worked fine.


Thus spake ChangingLINKS.com (x3 at ChangingLINKS.com):

> I am having a problem gettng my CD burner to work under Suse. Below is the 
> output of what is happened (looks like it is going to work and fails "OPC"). 
> Anyone else run into this problem?
> 
> Cdrecord 1.11a28 (i686-suse-linux) Copyright (C) 1995-2002 J?rg Schilling
> TOC Type: 1 = CD-ROM
> Using libscg version 'schily-0.6'
> atapi: 1
> Device type    : Removable CD-ROM
> Version        : 0
> Response Format: 1
> Vendor_info    : 'IDE-CD  '
> Identifikation : 'R/RW 4x4x24     '
> Revision       : 'C12a'
> Device seems to be: Generic mmc CD-RW.
> Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
> Driver flags   : SWABAUDIO 
> Supported modes: TAO PACKET RAW/R16
> Drive buf size : 1572864 = 1536 KB
> FIFO size      : 4194304 = 4096 KB
> Track 01: data    19 MB        
> Total size:       22 MB (02:14.21) = 10066 sectors
> Lout start:       22 MB (02:16/16) = 10066 sectors
> Current Secsize: 2048
> ATIP info from disk:
>   Indicated writing power: 6
>   Is not unrestricted
>   Is not erasable
>   Disk sub type: Medium Type C, low Beta category (C-) (6)
>   ATIP start of lead in:  -11231 (97:32/19)
>   ATIP start of lead out: 359848 (79:59/73)
> Disk type:    Short strategy type (Phthalocyanine or similar)
> Manuf. index: 27
> Manufacturer: Prodisc Technology Inc.
> Blocks total: 359848 Blocks current: 359848 Blocks remaining: 349782
> Starting to write CD/DVD at speed 4 in real TAO mode for single session.
> Last chance to quit, starting real write in 9 seconds.          8 seconds.          
> 7 seconds.          6 seconds.          5 seconds.          4 seconds.          
> 3 seconds.          2 seconds.          1 seconds.          0 seconds. 
> Operation starts.
> Waiting for reader process to fill input buffer ... input buffer ready.
> Performing OPC...
> 
> cdrecord: Input/output error. send opc: scsi sendcmd: no error
> CDB: 54 01 00 00 00 00 00 00 00 00 00 
> status: 0x2 (CHECK CONDITION)
> Sense Bytes: 70 00 03 00 00 00 00 13 00 00 00 00 00 73 00 00
> Sense Key: 0x3 Medium Error, Segment 0
> Sencse Code: 0x73 Qual 0x03 (power calibration area error) Fru 0x0
> Sense flags: Blk 0 (not valid)
> cmd finished after 7.3s timeout 60s
> cdrecord: OPC failed.
> cdrecord: fifo had 64 puts and 0 gets.
> cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
> -- 
> Wishing you Happiness, Joy and Laughter,
> Drew Brown
> http://www.ChangingLINKS.com
> _______________________________________________
> Ale mailing list
> Ale at ale.org
> http://www.ale.org/mailman/listinfo/ale

:wq!
---------------------------------------------------------------------------
Robert L. Harris                     | PGP Key ID: E344DA3B
                                         @ x-hkp://pgp.mit.edu 
DISCLAIMER:
      These are MY OPINIONS ALONE.  I speak for no-one else.

Diagnosis: witzelsucht  	

IPv6 = robert at ipv6.rdlg.net	http://ipv6.rdlg.net
IPv4 = robert at mail.rdlg.net	http://www.rdlg.net

 PGP signature




More information about the Ale mailing list