[ale] $TERM settings?

[Robert L. Harris]

I'm trying to enable color in my mutt email so certain people and lists
will be highlighted.  This is working great.  I've found one problem
though.  Since I changed $TERM to either xterm-color or rxvt my screen
session doesn't scroll anymore.  

If I set $TERM on my local workstation to rxvt, ssh to the remote box, 
set it there I can do an "ls -lar" and scroll works great.  I can page
up and my local terminal with a very large scroll buffer scrolls back
just great.  If i start screen, no more scrolling.  I can use the screen
scrolling but it's much easier to use the same scroll back in all my
term sessions (tend to run about 8-10 at a time).


Is there a $TERM setting that works better?  I didn't see anything that
stood out in my .screenrc either.


:wq!
---------------------------------------------------------------------------
Robert L. Harris                |  Micros~1 :
Senior System Engineer          |    For when quality, reliability
  at RnD Consulting             |      and security just aren't
                                \_       that important!
DISCLAIMER:
      These are MY OPINIONS ALONE.  I speak for no-one else.
FYI:
 perl -e 'print $i=pack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(115),10);'


---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
sent to listmaster at ale dot org.