[ale] Lite-On 1640

[Glenn C. Lasher Jr.]

On Mon, 17 Jun 2002, Dow Hurst wrote:

> dev=0,0,0 seems too much like the scsi controller.  Isn't more like 
> dev=0,1,0 or some such beast?  Is the ide-scsi emulation setup right?
> Dow

The controller would most likely be 0,0,7 for all devices 0,0,*.  Thus, 
older SCSI devices attached to a controller could be given targets of 0-6.  

Empirically, I can tell you that under ide-scsi, 0,0,0 works if there is 
not other SCSI interface, otherwise, the other SCSI interfaces get lower 
interface numbers.  In my particular case, my CD burner is 1,0,0, because 
I have a low-end Symbios SCSI card in there to connect my scanner.

cdrecord -scanbus will remove all doubt.

> 
> cfowler wrote:
> 
> >Is there a secret to getting the LITE-ON 1640 CD-RW to work under
> >RH7.3?  Here is what I get:
> >
> >
> >
> >[root at cfowler tmp]# cdrecord -v -speed=2 -dev=0,0,0 -data ./l.iso
> >Cdrecord 1.10 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
> >TOC Type: 1 = CD-ROM
> >scsidev: '0,0,0'
> >scsibus: 0 target: 0 lun: 0
> >Linux sg driver version: 3.1.22
> >Using libscg version 'schily-0.5'
> >atapi: 1
> >Device type    : Removable CD-ROM
> >Version        : 0
> >Response Format: 1
> >Vendor_info    : 'LITE-ON '
> >Identifikation : 'LTR-16102B      '
> >Revision       : 'OS06'
> >Device seems to be: Generic mmc CD-RW.
> >Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
> >Driver flags   : SWABAUDIO
> >Drive buf size : 1966272 = 1920 KB
> >FIFO size      : 4194304 = 4096 KB
> >Track 01: data    0 MB         padsize: 280 KB
> >Total size:       0 MB (00:04.02) = 302 sectors
> >Lout start:       1 MB (00:06/02) = 302 sectors
> >Current Secsize: 2048
> >ATIP info from disk:
> >  Indicated writing power: 4
> >  Is not unrestricted
> >  Is not erasable
> >  Disk sub type: Medium Type A, high Beta category (A+) (3)
> >  ATIP start of lead in:  -11849 (97:24/01)
> >  ATIP start of lead out: 359848 (79:59/73)
> >Disk type:    Long strategy type (Cyanine, AZO or similar)
> >Manuf. index: 25
> >Manufacturer: Taiyo Yuden Company Limited
> >Blocks total: 359848 Blocks current: 359848 Blocks remaining: 359546
> >Starting to write CD/DVD at speed 2 in write mode for single session.
> >Last chance to quit, starting real write in 0 seconds. Operation starts.
> >Waiting for reader process to fill input buffer ... input buffer ready.
> >Performing OPC...
> >Starting new track at sector: 0
> >Track 01:   0 of   0 MB written.
> >Track 01: writing 280 KB of pad data.
> >Track 01: Total bytes read/written: 327680/614400 (300 sectors).
> >Writing  time:   27.970s
> >Fixating...
> >
> >cdrecord: Input/output error. close track/session: scsi sendcmd: no
> >error
> >CDB:  5B 00 02 00 00 00 00 00 00 00
> >status: 0x2 (CHECK CONDITION)
> >Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 72 00 00 00
> >Sense Key: 0x3 Medium Error, Segment 0
> >Sense Code: 0x72 Qual 0x00 (session fixation error) Fru 0x0
> >Sense flags: Blk 0 (not valid)
> >cmd finished after 113.069s timeout 480s
> >cmd finished after 113.069s timeout 480s
> >Fixating time:  113.095s
> >cdrecord: fifo had 6 puts and 6 gets.
> >cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
> >[root at cfowler tmp]#
> >
> >
> >Do I need to run Windows to burn on this thing?
> >
> >
> >
> >
> >---
> >This message has been sent through the ALE general discussion list.
> >See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
> >sent to listmaster at ale dot org.
> >
> >
> >  
> >
> 
> 
> ---
> This message has been sent through the ALE general discussion list.
> See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
> sent to listmaster at ale dot org.
> 

-- 
glasher at nycap.rr.com
You've been programmed by the Illuminati not to see the word "".


---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
sent to listmaster at ale dot org.