[ale] eth0?

[George Johnson]

Did you see it in dmesg?  If so you may just need to run "ifconfig eth0 up"
to see it with the "ifconfig -a" command.  I use the "pump eth0" command to
get it to use dhcp after that.  Hope that works.

gj

-----Original Message-----
From: ChangingLINKS.com [mailto:x3 at ChangingLINKS.com]
To: ale at ale.org
Sent: Monday, August 12, 2002 8:50 PM
To: ale at ale.org
Subject: [ale] eth0?


Did an install of RedHat 7.2 today, and Linux would not recognize my LAN
card. I have been using the same hardware and installation disks for 6
months
- and it always recognizes the card fine. I put in a Windows drive, and was
able to browse the Internet without touching the hardware.
Does anyone know why the card was not recognized this time?

Rather than beg for the commands to get the card up, I am re-installing the
entire OS again - still it would be nice to know what happened.
--
Wishing you Happiness, Joy and Laughter,
Drew Brown
http://www.ChangingLINKS.com

---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be
sent to listmaster at ale dot org.



---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
sent to listmaster at ale dot org.